Advanced XP 2K Instructions

It is important that both wood and floor finish have a temperature of min. 59°F (preferably around 68°F) and air humidity of approx. 50%. Make sure that the room is well-ventilated for optimal evaporation and drying time. For the final sanding to bare wood, use grit 100-120 sandpaper or sanding pad. Vacuum thoroughly and tack the floor afterwards, using a tightly-wrung water-soaked mop/cloth. The floor must be completely dry before sealing. When sealing, use WOCA Sealers for newly sanded wood to reduce side bonding.

Always remember to test on a less visible spot to check the compatibility of the surface with the product.

1. Apply the sealer if not using a stain. When dry, mix Advanced Hardener US with the floor finish and shake thoroughly before use. Leave the mixture to stand for ten minutes before use, to allow the hardener to activate.
2. A coat of Advanced XP 2K US Lacquer should be applied undiluted, using a brush or roller. Leave the surface to dry until next day.
3. Sand the surface with 120-200 and vacuum clean the surface thoroughly.
4. Apply the final coat of Advanced XP 2K US with hardener (freshly mixed).

Water and colored fluids, such as red wine and coffee, must be wiped off immediately to prevent staining.