Natural Sealer instructions

It is important that both wood and product have a temperature of min. 59°F (preferably around 68°F) and air humidity of approximately 40-60 %. Make sure that the room is well-ventilated for optimal evaporation and drying time. Untreated floors must be free of dirt, grease, wax and dust. Floors that have been finished previously must be sanded down to bare wood before the sealer is applied. Vacuum thoroughly and tack the floor afterwards if necessary, using a tightly-wrung water-soaked cloth. Shake the Natural Sealer thoroughly before use.

Always remember to test on a less visible spot to check the compatibility of the surface with the product.

1. Apply sealer undiluted with brush or roller, lengthwise, and allow the surface to dry.
2. Sand the surface with 120-180 grit and vacuum clean the surface thoroughly.
3. Apply a 1 coat of WOCA Water Based Finish. Leave the surface to dry until next day.
4. The next day, apply another 1-2 coats of WOCA Water Based Finish (refer to specific WOCA Water Based Finish product for recommended number of coats).

When using a WOCA Sealer, only 2 coats can applied each day, either 2 coats of Sealer OR 1 coat of Sealer and 1 coat of WOCA Water Based Finish.