WOCA RP 2K instructions

It is important that both wood and finish have a temperature of min. 59°F (preferably around 68°F) and air humidity of approx. 50%. Make sure that the room is well-ventilated for optimal evaporation and drying time. For the final sanding to bare wood, use grit 120-150 sandpaper or sanding pad. Vacuum thoroughly and tack the floor afterwards with a tightly-wrung water-soaked cloth. The floor should be completely dry before application of WOCA RP 2K

Always remember to test on a less visible spot to check the compatibility of the surface with the product.

1. Mix WOCA 2K Pure hardener with the WOCA RP 2K Finish and shake thoroughly before use. Leave the mixture to stand for ten minutes before use, to allow the hardener to activate.
2. Apply a coat of the mixture with a paint roller or brush and leave the floor to dry for 2-3 hours.
3. Apply the second coat and leave the surface to dry until the next day. The floor can be sanded after .
4. Sand the surface with 120-150 and vacuum clean the surface thoroughly.
5. Apply the final coat of WOCA RP 2K with hardener (freshly mixed).

Water and colored fluids, such as red wine and coffee, must be wiped off immediately to prevent staining.